1. Chip Reading

jcan

1. Click"Read ID". If the ID is correctly identified, the two columns to theright will display the correct chip parameters.

2. Set thedirectory to save the image.

3. Click the readbutton to read the image.

4. When replacinga chip, switch to a different chip.

5. After readingthe correct ID, you can skip steps 2-4 and directly preview the chip content.

6. Otherparameters: 1. Chip type: Std,WL,05_E0,A2,DA,3B,WL4 etc., refer to the type of read commandsent.

                              2. Reread command:Based on the specific parameter values obtained from the reread test.

                              3. There are twopower supply modes: voltage setting: specific voltage value.

                              4. Slow Read: Readspeed is halved. Ignore RB: Delay RB response time.

Preview directlyafter reading the ID: